I integrated the Geiger-Müller shield with FPGA examples used for educational programs I am involved with.
The video is here https://youtu.be/IQ6o_dLLRvY
My design is here https://github.com/yuri-panchul/basics-graphics-music/blob/main/labs/17…
It is obvious I had to buy a board with two bulbs (two bulbs make a more interesting demo).
I created a bin image of the 781220 using cartconv from vice. It reports that it starts at $e000. I programmed the 29f040 and tried it but no go. I see how to configure the rom image sizes but I'm not clear about the starting address. I would appreciate some assistance on this.
Thanks!
I'm trying to run some 8K cartridge images from a Unicart without much luck. I read the 512K of data from the PLCC32 that came with my Unicart using a MiniPro. I then edited the file using HxD Hexeditor and pasted in 3 8K cartridge BINs at 2000h, 4000h and 6000h. I then burned the image to a new M290F040B successfully. What should my DIP settings be for P2 and P1 to run each of those carts at 200h, 4000h and 6000h?
Thanks!
Does your A2SCSI card fully support removable media (ZIP drives) in the same way as the Ramfast card?
Thanks.
Is it possible to reprogram this while it is inside the Macintosh? Do your MACSIMMs come pre-programmed with the 0.9.6 version which supports the http://synack.net/~bbraun/macromboot.html ROMDriver Control Panel?
Hello,
I have 4 of you F2R16's that I purchased a while ago. Now that AmigaOS 3.1.4 is out I want to burn the ROM to my cool new toys. I have a GQ-4X programmer and it negatively supports the 27c400 chips and the 29F400T or B. Do you know if it would be possible to just put in the F2R16 in the GQ-4x and tell it it is a 27C400? I guessing it would blow up the 29F400, but not sure. Any help would be appreciated.
I there, I built my F2R16-PROG, but can't find any steps documented on how to actually program my F2R16 with MiniProg. Any guidance would be much appreciated.
hello. Nice work on the thermocouple breakout. I'm a scientist and I plan to use the MAX31855K to store the oven temperature of a gas chromatograph. However, I am not going to use the flash ROM (I'm using an SD card instead), so I am planning to make a different breakout without the flash ROM (to save some space when fabricating the board). If you could post the board files and/or Eagle/Kicad schematics that would be appreciated, but if not I understand. Also, I'm a beginner at board fabrication, so forgive me if what has been posted is sufficient for this modification.