GLINK

Trying to get some help concerning a new GLINK 232T, I am getting nonstop RS232 Break Errors from BBS Server v1.4a and Image BBS both v2.0 and v1.2, I have tried to contact you guys via the contact button but I don't think it is going through. This board was purchased new in December of 2018 and not used until this past weekend. Any ideas on how to get this board to work? It sounds like a baud rate issue but the software is set correctly, I am not sure the board has dropped down in speed though... Any help would be appreciated...

Your description of the GLINK-LT says jumpers J3 and J4 can be used to configure for 9600 baud but I can find nothing saying how they are to be configured.

I am using the GLINK-LT in the user port of my SX-64. It is connected via a standard telbbs cable (7 wires) to my PC running BBS Server. Communication between the GLINK-LT and BBS Server remains at 2400 baud whether the J3 and J4 jumpers are on or removed. If I set BBS Server for 9600 baud, the log reports "RS232 error. Framing error! (Check baud rate)".

Hi

How did you guys connect this to a modern OS ?

I have a serial to usb lead and then...

I've tried virtual modem software , serial port software and various versions of them.

I can communicate with the 64 via zterm but no internet / bbs access.

I'll end up with a pi or arduino solution at this rate .
Mike