GLINK 232T

Forums: 

Trying to get some help concerning a new GLINK 232T, I am getting nonstop RS232 Break Errors from BBS Server v1.4a and Image BBS both v2.0 and v1.2, I have tried to contact you guys via the contact button but I don't think it is going through. This board was purchased new in December of 2018 and not used until this past weekend. Any ideas on how to get this board to work? It sounds like a baud rate issue but the software is set correctly, I am not sure the board has dropped down in speed though... Any help would be appreciated...

Sounds like you have a defective board.
Please send us an email to start a RMA