Project has been retired because a newer and improved version of the design has been released.
The Apple II SCSI card from 1986 was one of the first interface cards to attach a Hard Disk Drive to the Apple II line of computers. A2SCSI is a clone of the last revision (rev.C) of the card with a few enhancements to improve compatibility with modern SCSI drives.
Like many other hobbyist we have always been fascinated by radioactivity and the sensors to detect it. Geiger-Müller tubes are a common and relatively inexpensive way to measure radiation. GRAD is a complete solution for radiation counting in an Arduino shield form factor. Its main features are dual tube support to increase sensitivity and very low power consumption.
Like many other hobbyist we have always been fascinated by radioactivity and the sensors to detect it. Geiger-Müller tubes are a common and relatively inexpensive way to measure radiation. GRAD is a complete solution for radiation counting in an Arduino shield form factor. Its main features are dual tube support to increase sensitivity and very low power consumption.
The PCPI Appli-Card was the first single board computer style CP/M card for the apple II. It featured a 6MHz Z-80 CPU paired with 64KB of RAM and 2KB of ROM. Thanks to the high clock and zero wait states DRAM accesses the card performed almost 3 times as fast as the Microsoft SoftCard. The GZ/80-B00 is a new implementation of the PCPI card with a 20MHz Z-80 CPU and 512KB of static RAM.
The Microsoft Softcard was the first card to allow CP/M software to run on the Apple II. It was originally developed to simplify the porting of Microsoft Basic to the Apple II. It turned out to be a great success and at some point in time it was the most popular CP/M platform in use.
This success prompted the development of many compatible cards. Some exact copies, some enhanced or cost reduced. The GZ/80 is a modern implementation of a Softcard compatible card with an additional turbo mode with approximately double the speed of the original card.
The Apple II SCSI card from 1986 was one of the first interface cards to attach a Hard Disk Drive to the Apple II line of computers. A2SCSI is a clone of the last revision (rev.C) of the card with a few enhancements to improve compatibility with modern SCSI drives.
Many MCU applications use electro-mechanical relays to control AC loads. While this is an excellent solution for occasionally turning on/off a load, it is not suited for frequent switching or PWM applications. SSR1/A is an opto-coupled solid state relay that can control two AC loads in a arduino shield form factor.